Robotronics Buzz E Instrukcje Operacyjne Pobierz pdf (Strona 8)

Chapter 1 Getting Started: Setup and How to Operate the Robot

SETUP AND HOW TO OPERATE

Step # 1 Read the manual

Read and study this manual completely before operating system.

For connecting the wiring, follow the letters and description labels on the wiring and

components of the system.

Step # 2 Attach the Smoke Alarm on the base unit

The Smoke Alarm usually comes attached to the base unit already. If you need to connect it,

this is how.

1. Connect the Smoke Alarm control wires to the base unit. These are two wires coming up

through the hole on the base. Match these wires with the same colors coming out of the

Smoke Alarm. One is Blue/Orange/Yellow and the other is Green/White.

2. Set the Smoke Alarm in position over the holes in the base.

3. With the Smoke Alarm in position on top of the base unit, Screw the two screw knobs into

the bottom of the Alarm to secure it.

Step # 3 Fold out the House of Hazards

1. Open the two side latches and open the House on a table.

2. Remove the front panels by lifting up to clear the bottom metal catches and then pulling the

bottom out. To install the panels put the top up and in first and then lower the bottom metal

catches in at the bottom. You can see the slots in the plastic at the bottom of the opening.

3. Install the chimney on the top of the House.

Connecting the extension wires (depends on the package that you have)

1. Smoke Alarm, House and Controls- Two extensions are used; base unit to House and

control box to base unit.

2. Smoke Alarm and House- Connect the extension from the base unit to the House in the

back.

3. Smoke Alarm and controls only- One extension from control box to base unit.

Step # 4 Powering Up

1. Connect the power supply Red/Black wire to the Red/Black connector on the back of the

base unit.

2. Connect the power supply AC cord to a 110 Volt AC outlet.

3. Turn the power supply on (or connect the battery to the back of the House if you have this

option).

4. When you are ready to turn it on, turn on the switch at the back of the Smoke Alarm base

unit. This powers up the entire system.

Step # 5 Running the House and Smoke Alarm on Automatic Mode:

1. Insert the programmed CD into the CD player or turn on the MP3 player.

2. To run the House on automatic mode, press play on the CD/MP3 player.

3. The House and Smoke Alarm will go through a program of songs. You can run it from one

track to the next continuously or you can select tracks.

4. Set the volume levels. There is a volume on the back of the Smoke Alarm base unit and

volume controls on the operator control box for the music/Smoke Alarm voice and headset

hearing levels. If you have a MP3 player, set the volume at the maximum level, then you

can adjust the master volumes where you want them.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 40 41

Komentarze do niniejszej Instrukcji

Brak uwag

Robotronics Buzz E Instrukcje Operacyjne Strona 8

Komentarze do niniejszej Instrukcji