Robotronics Buzz E Instrukcje Operacyjne Pobierz pdf (Strona 29)

Siren

CHAPTER 5 Siren

The robot siren is operated by remote control from the Radio Control Transmitter. The siren

circuitry is located on the main circuit board. See the Main Electronics Box diagram, in the

Appendix, for the location of the siren volume, mode select and oscillation frequency adjust.

The volume of the siren is controlled by a trim pot on the main board. Turning the pot

clockwise will increase the volume of the siren. Turn the pot counterclockwise to decrease

volume. Three different sirens are available. Choose the siren you want by moving the jumper

located on the siren mode select. To control the oscillating speed, adjust the siren frequency

trim pot in the siren circuit. The siren mode select is set to the common siren for your robot. If

the siren mode select is changed, the siren frequency will very likely need to be adjusted.

NOTE: The volume and oscillation are preset at the factory and do not need to be adjusted

unless you want a different volume level or oscillation speed.

Troubleshooting – Siren

Problem/Cause Action

Siren

No siren

1. Audio fuse blown

1. Replace fuse. See fuse block diagram.

Siren volume not loud enough

1. Booster problem if tape and voice vol. also are not loud

enough.

2. Adjust siren volume if tape and voice okay.

1. Replace or have booster repaired.

2. See siren volume adjust on main board.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 60 61

Brak uwag

Robotronics Buzz E Instrukcje Operacyjne Strona 29